Handy Mains Power Adaptors (2700W)
2700w Handy Mains Power Adapters.
VIRTUALLY SILENT USE (FAN ONLY).
HIGH OUTPUT POWER IN COMPACT SIZE.
LATEST ‘POWER PUSH’ © SURGE HANDLING.
VERY HIGH CONVERSION EFFICIENCY.
REMOTE ON / OFF CONTROL FACILITY.
GENERAL DESCRIPTION: Floor mounting battery inverters, generating mains level power, capable of powering most equipment from any 24 or 48 volt battery system (model specific). Models with appropriate sockets are available to suit all countries.
Input is isolated from case by up to 63V. The output is isolated via a safety barrier from the input.
The output is a stepped quasi AC sine wave of nominally 230V RMS with a peak voltage appropriate to European mains. The output is suitable for almost all equipment. 115V RMS variants are also available.
The specification allows for up to 2700 watts of continuous power to be used, with up to 2 minutes at 3500 watts, accommodating disk drive run-up, motor start, etc. New ‘power push’ technology usually allows operation of equipment drawing a starting surge of over 12 kilowatts.
The battery input is via flat 5 mm screw terminals mounted on the rear of the unit. The unit may be turned off and on remotely, by a low current control input supplied from battery positive via a small switch.
CONNECTION: Heavy Duty Wiring Kits, part no's. SM2793 and SM2795, are available consisting of 16mm2 cable, 2 metres long, terminated in suitable heavy duty eyelet terminals. The SM2795 is for use with 48V units.
BATTERY SELECTION: Only heavy duty (high discharge rate) batteries are suitable as a power source. Fully sealed types should be used in enclosed spaces (especially inside the home). Ordinary car batteries are only suitable in well ventilated areas.
CAUTION: This adapter is supplied on the basis of the user determining the suitability for the purpose for which it is to be used. Not for life dependent use. Total Live to Neutral load capacitance must not exceed 3.0uF (6.0uF in 115VAC units).
115VAC models available:
| SM4360 24V screw terminal input, 2 x 16A CEE form outlets. | SM4365 48V screw terminal input, 2 x 16A CEE form outlets. |
| SM4361 24V screw terminal input, 2 x IEC (KETTLE). | SM4366 48V screw terminal input, 2 x IEC (KETTLE). |
| SM4262 24V screw terminal input, 2 x EURO SHUKO. | SM4267 48V screw terminal input, 2 x EURO SHUKO. |
|
|
INPUT SPECIFICATION |
|
|
|
24V TYPES |
48V TYPES |
|
Battery: |
24V Nominal car battery (not leisure types). |
48V Nominal battery (not leisure types). |
|
Voltage Range: |
22-30V. |
43.2-64V. |
|
Current, No Load: |
0.6A typical. |
0.3A typical. |
|
Current Drawn Per 10W Load |
0.5A. |
0.2A. |
|
Input Fuse Rating: |
12 x 20A Standard auto blade fuses (yellow). |
4 x 60A Fuses. |
|
Remote On/Off Power: |
<1mA when the unit is not switched on by the remote lead (Bat +VE & -VE still connected). |
|
|
|
||
|
|
OUTPUT SPECIFICATION |
|
|
Output Voltage: |
115VAC ± 7VAC RMS, 23.5A continuous max. |
|
|
Frequency: |
50 Hz nominal, 48-53Hz. |
|
|
Power, Nominal: |
2700 Watts continuous (resistive load). |
|
|
Power, Short Term: |
3500 Watts for 2 minutes. |
|
|
Max Capacitive Load: |
6.0uF direct Live to Neutral capacitance (Class X). |
|
|
Output Wave Form: |
Quasi sine wave (stepped square wave). |
|
|
Protection: |
Current and temperature limited, Internal fuses for surge and reverse connection protection. |
|
|
|
|
|
|
|
GENERAL |
|
|
Size: |
170mm x 280mm x 180mm. |
|
|
Weight: |
6 Kg. |
|
|
Storage Temperature: |
-40 to +70C. |
|
|
Operating Temperature: |
-20 to +35C. |
|
230VAC models available:
| SM4360 24V screw terminal input, 2 x UK outlets. | SM4365 48V screw terminal input, 2 x UK outlets. |
| SM4361 24V screw terminal input, 2 x IEC (KETTLE). | SM4366 48V screw terminal input, 2 x IEC (KETTLE). |
| SM4262 24V screw terminal input, 2 x EURO SHUKO. | SM4267 48V screw terminal input, 2 x EURO SHUKO. |
| SM4263 24V screw terminal input, 1 UK & 1 SHUKO outlets. | SM4268 48V screw terminal input, 1 UK & 1 SHUKO outlets. |
|
|
INPUT SPECIFICATION |
|
|
|
24V TYPES |
48V TYPES |
|
Battery: |
24V Nominal car battery (not leisure types). |
48V Nominal battery (not leisure types). |
|
Voltage Range: |
22-30V. |
43.2-64V. |
|
Current, No Load: |
0.6A typical. |
0.3A typical. |
|
Current Drawn Per 10W Load |
0.5A. |
0.2A. |
|
Input Fuse Rating: |
6 x 20A Standard auto blade fuses (yellow). |
4 x 60A Standard auto blade fuses (tan). |
|
Remote On/Off Power: |
<1mA when the unit is not switched on by the remote lead (Bat +VE & -VE still connected). |
|
|
|
||
|
|
OUTPUT SPECIFICATION |
|
|
Output Voltage: |
230VAC RMS ± 10%, 11.5A continuous max. |
|
|
Frequency: |
50 Hz nominal, 48-53Hz. |
|
|
Power, Nominal: |
2700 Watts continuous (resistive load). |
|
|
Power, Short Term: |
3500 Watts for 2 minutes. |
|
|
Max Capacitive Load: |
6.0uF direct Live to Neutral capacitance (Class X). |
|
|
Output Wave Form: |
Quasi sine wave (stepped square wave). |
|
|
Protection: |
Current and temperature limited, Internal fuses for surge and reverse connection protection. |
|
|
|
|
|
|
|
GENERAL |
|
|
Size: |
170mm x 280mm x 180mm. |
|
|
Weight: |
6 Kg. |
|
|
Storage Temperature: |
-40 to +70C. |
|
|
Operating Temperature: |
-20 to +35C. |
|